And Pin 7 should be connected to GND via 1K Ohm resistor. Power-ON button connects ground to the main controller via 220 Ohm resistor.

Pin 7 - Panel Sense? (does not work without this one). I used the components from the original control panel and put them on a small peace of veriboard. And it should help out for people that has these printers with failed control panels (have seen a few of those). So decided to make the control panel smaller. To initiate the scan, click on the scanning shortcut button to initiate the scan.Since I do this project on free time it is important that I could put it away without taking a lot of space.Clicking on the 'Close' button will save all of your settings.Select the 'Option:' tab and then click on the Job assignment drop-down button to choose from the drop-down list.If you wish to assign a Job number to the newly created scanning shortcut, click on the pencil icon.Click on the 'Save to Shortcut' button in the bottom right hand of the screen (see step 3 below).Īfter clicking on this button a new icon will appear on the right hand of the screen under 'Scanning Shortcut). Clicking on the pencil icon allows you to change any of the specific settings for this shortcut.You can also edit the settings of the output by clicking on the pencil icon. Select the output type you wish to you by clicking on it (see step 2 below).You can click on the pencil icon to adjust the settings that you need or, if you wish, click on 'New document' to create a new set of specific settings that you require. Select the document type by clicking on one of the icons listed in section 1 'Select document' (see step 1 below).Open CaptureOnTouch (make sure you have your scanner selected first).

Scanning with a canon mp210 printer